气体增压泵利用大面积活塞端的低压气体驱动而产生小面积活塞端的高压流体，可用于压缩空气及其它气体，输出气体压力可通过调节驱动气体压力实现无级调节。那么气体增压泵的使用要注意什么呢？
The gas booster pump uses the low-pressure gas at the large-area piston end to drive and produce the high-pressure fluid at the small-area piston end, which can be used to compress air and other gases. The output gas pressure can be adjusted steplessly by adjusting the driving gas pressure. So what should we pay attention to when using the gas booster pump?
二、使用注意事项：
2、 Precautions for use:
1、压缩空气作为驱动气体进入增压泵前必须使用油水分离器去除冷凝水、油污或者杂质；
1. Before compressed air enters the booster pump as driving gas, an oil-water separator must be used to remove condensate, oil stains or impurities;
2、预增气体（氢气、氮气、氦气等）通过增压后，可能也会有水凝结出来，并且泵内也会发生磨损，因此泵的气体输入口和高压输出口都必须加过滤器；
2. Water may condense out of the pre increased gas (hydrogen, nitrogen, helium, etc.) after pressurization, and wear will also occur in the pump, so the gas input port and high-pressure output port of the pump must be equipped with filters;
3、如果，输出端用气设备内压力低于入口预增气压力时，设备可通过单向阀向设备内部直接充气，因此可节省充气时间；
3. If the pressure in the gas equipment at the output end is lower than the pre increased gas pressure at the inlet, the equipment can directly inflate the equipment through the one-way valve, so the inflation time can be saved;
4、考虑到工况的不同，设备的输出高压力可预先储存到高压气罐中（气罐的容积大小请咨询技术工程师），根据用气设备的使用压力要求，使用减压阀来调节出口压力；
4. Considering the different working conditions, the output high pressure of the equipment can be stored in the high-pressure gas tank in advance (please consult the technical engineer for the volume of the gas tank). According to the pressure requirements of the gas equipment, the pressure reducing valve is used to adjust the outlet pressure;
5、气体增压泵入口侧压缩空气流量约为泵出口侧流量的2倍（增压设备的预增气体通过增压，中间会产生损耗）；
5. The compressed air flow at the inlet side of the gas booster pump is about twice the flow at the outlet side of the pump (the pre increased gas of the booster equipment will be lost in the middle through pressurization);
6、
气体增压泵的寿命是由动作的频率决定。因此如果设备需要长时间运转，请在工况中说明，我们的技术部会讨论决定泵的类型，这样会大大增压气体增压设备的使用寿命期限。
6. The service life of gas booster pump is determined by the frequency of action. Therefore, if the equipment needs to operate for a long time, please explain it in the working condition, and our technology department will discuss and decide the type of pump, which will greatly increase the service life of the pressurized gas pressurized equipment.
In addition, the gas booster pump has a wide range of applications, such as static and burst tests for pipe fittings, hoses, valves, pressure vessels, cylinders, etc; Detection of air pressure regulator; Destructive test of geological samples. wait. Of course, you should pay attention to safety in use. For more information, go to the website http://www.feileisi.com Consult.
